Industrial Control Products

WAGO 862-2505: 4-conductor chassis-mount terminal strip with push-in CAGE CLAMP technology, suitable for side-entry wiring.

Gray, single-deck 2-conductor through terminal block with lateral marker slots, designed for DIN-rail 35 x 15 and 35 x 7.5 mm, using CAGE CLAMP spring connections.

WAGO 4-conductor terminal block for rail mount, without push-buttons, with fixing flange and 1.5 mm² wire cross-section.

This 2-conductor through terminal block is designed for reliable connections, with a cross-section of 6 mm² and compatibility with DIN-rail 35 x 15 and 35 x 7.5. It is suitable for Ex i applications and uses CAGE CLAMP® technology.

4-conductor chassis-mount terminal strip, 3-pole, no ground contact, for 3 mm ø screw and nut, 4 mm², white.

Separator for Ex e/Ex i applications, 3mm thick, 90mm wide, orange.

4-conductor chassis-mount terminal strip, 3-pole, without ground contact, suitable for 4 mm² wire cross section.

WAGO 2002-1707 is a 3-conductor ground terminal block with Push-in CAGE CLAMP technology, suitable for DIN-rail 35 x 15 and 35 x 7.5.

WAGO 235-506/331-000 is a 6-pole PCB terminal block featuring a push-in CAGE CLAMP® connection method, suitable for wires up to 1.5 mm².

3-pin THT PCB header, 5.08mm pitch, orange, vertical mount. Meets IEC/EN 60664-1. Polyamide 6.6 insulation, UL94 V-0 rated.

12-pole male header connector with THT, angled pins, 5mm spacing, and up to 16A nominal current.

Low-profile PCB terminal strip with PUSH WIRE® connection, 8-pole, 2.5 mm², and 5/5.08 mm pin spacing.

Stackable 2-conductor PCB terminal block with PUSH WIRE® technology, 0.75 mm² cross-sectional area, and 5/5.08 mm pin spacing.

WAGO 281-347 separator plate, 2mm thick, light gray, for DIN rail terminal blocks.

The WAGO 279-492 is a 2-way insulated jumper for rail-mounted terminal blocks, designed for reliable electrical connections.

Stackable PCB terminal block with 1 pole, 2.5 mm² cross-section, and PUSH WIRE® connection technology.

WAGO 721-103/008-045 female connector, 2.5 mm², 3-pole, CAGE CLAMP, snap-in mounting, 100% mismating protection.

WAGO 235-700 end plate, snap-fit type, 1 mm thick, light green. For terminal blocks.

5-pole PCB terminal block with push-in CAGE CLAMP®, 1.5 mm² wire size, and 7.5/7.62 mm pin spacing.

WAGO 2002-1441 double potential terminal block for DIN-rail, 2.5 mm², Push-in CAGE CLAMP®, double center marker slot.